Installation specification

Apartment house Moscow

Apartement house
Moscow

Installation specification

In the process of work with fibercement boards you should follow directions:

Transportation

  • The number of boards in a package must not exceed 50 panels, you can not put more than three packages above each other during transportation.

Warehousing

  • You cannot store a facade plates without polyethylene film between them, it will lead to stick together plates and damaging the coating.
  • Panels can be stored in a horizontal position only.
  • Panels must be stored under a shed or indoors.
  • If panels are stored outdoors even unopened pallets should be covered with a film, so that moisture does not drip into the package. Moisture causes the damage of the coating.
  • When you open the pallets each panel should come up with care not to scratch the surface of the panel, located at the bottom.

Befour installing

  • Be sure to check the date of issue. Plates of different parties may be of different shades.
  • Make sure that on the stove there are no defects. If You see any damage, contact your Manager or other representative of TD LTM.
  • After the plate was installed, it shall be considered adopted.
  • Move the panel should not be less than two persons. When transferring the panels should be kept in an upright position to prevent damage.

After installing

  • Facade panels of LTM do not require special care. If necessary, they can be washed with water without a lot of pressure, using a mild soap solution.